Electroplating Equipment in Colombia: Resolución 631 Limits
Colombia publishes metal discharge limits you can design against. Plan precipitation, polishing and monitoring to Resolución 631 with margin for revisions.

What the rules actually require
The treatment train that solves it
Stage | What it does | Equipment to specify |
|---|---|---|
1 · Segregated collection | Keeps cyanide, hex-chrome and acid streams apart so they cannot react in the drain | Separate sumps and drainage channels per stream, labelled and bunded |
2 · Cyanide oxidation | Destroys free cyanide before it reaches the metal-removal stage | Alkaline chlorination with sodium hypochlorite, ORP-controlled dosing, retention tank |
3 · Hexavalent chrome reduction | Converts Cr(VI) to Cr(III) so it can precipitate | Acidified reduction tank with bisulfite/metabisulfite dosing on ORP control |
4 · Metals precipitation | Drops dissolved metals out as hydroxide solids | pH-controlled lime or caustic dosing, polymer flocculation, flash-mix then flocculation chambers |
5 · Clarification | Separates the solids from the water | Lamella clarifier or DAF unit with sludge bleed |
6 · Polishing | Catches fines and residual metals to hold tight limits | Sand or multimedia filter, ion-exchange polishing where limits are tight |
7 · Final pH trim and monitoring | Returns the water to the permitted band and proves it | pH trim dosing, flow meter, composite sampler or online probe at the outlet |
8 · Sludge handling | Turns wet solids into a disposal-ready cake | Filter press or sludge drying bed, containment and manifest-ready storage |
Colombia-specific notes
- Read the annex that covers electroplating-type operations — sector annexes can carry tighter values.
- Confirm your licensing pathway (ANLA vs CAR) by capacity and location.
- Design margin in the treatment plant: resolutions get revised and annexes can tighten.
Five ways compliance projects actually fail
- The pH doser that nobody maintains. Metal removal stands or falls on precipitation pH. A single dosing pump with no redundancy, no alarm and no calibration schedule is the most common cause of effluent excursions. Specify dual pumps with auto-changeover and alarm escalation.
- Streams mixed too early. Cyanide and acid streams meeting in one sump generate HCN gas; chrome and cyanide in one tank poison each other's treatment. Segregation is civil-works scope — pour the channels when you pour the floor.
- No equalization. Rack dumps create peak flows that overwhelm a clarifier sized for averages. An equalization tank at the front of the train flattens the load and shrinks the equipment downstream.
- Treatment sized for commissioning, not production. Full racks load the effluent three times harder than the commissioning run. Size for the production case, with sample data from a comparable line if possible.
- Records that live in a notebook. Inspectors, auditors and customers all ask for history. Instrumented treatment data with retention in the control system turns a stressful inspection into a file hand-over — the scope is in the controls and traceability guide.
What drives cost and timeline
Key takeaways
- Design the treatment plant to the published limits — they are quantified and quotable.
- Confirm the annex covering your operation; sector values can be tighter.
- Monitoring points and records are part of the licence conversation.
- Counterflow rinsing keeps load within the plant's envelope as capacity grows.
- Margin and expandable stages are the hedge against revisions.
Your next five steps
- Confirm the discharge destination, the applicable annex and your licensing pathway.
- Define the treatment train to the resolution's values for your metals.
- Specify monitoring points and methods the licence will require.
- Get the written scope reviewed by the authority before ordering.
- Order treatment and line as one package with documented loads.



